- Process Optimization - Flow Measurement
- Process Optimization - Flow Detection
- Process Optimization - Moisture measurement
- Process Optimization - Velocity
- Process Optimization - Level Monitoring
- Process Optimization - Gas Monitors - Measured Parameter - CH4
- Process Optimization - Gas Monitors - Measured Parameter - CO
- Process Optimization - CO2 Gas Monitors - Measured Parameter CO2
- Process Optimization - Gas Monitors - Measured Parameter - NO
- Process Optimization - Filter Performance Monitors
- Process Optimization - Broken Filter Bag Detection
- Process - Leak Monitors
- Process - Dust Monitors
- Process - Particle Size Monitoring
- Process - Mercury Instruments
- Emissions & Process - Gas Monitors
- Emissions - Particulate CEMS
- Emissions - Mercury Instruments
- Emissions - Permanent Samplers
- Emissions - Flue Gas Velocity CEMS
- Emissions - Sampling Systems
- Emissions - Engine Exhausts Monitoring
- Ambient - Air Quality Gas Monitors - O3
- Ambient - Air Quality Gas Monitors - SO2
- Ambient - Air Quality Gas Monitors - NO/NO2/NOx
- Ambient - Air Quality Gas Monitors - VOC
- Ambient - Hg Monitors - Mercury
- Ambient air quality - Particulate monitors - PM10 / PM2.5
- Ambient air quality - Particulate Monitors
- Ambient - Air quality monitoring & Laboratory Mercury Instruments
- Ambient - Odors detection & Air quality monitoring Micro-Sensors
- Ambient - Gas Generators / Calibrators
- Air Quality Monitoring - Gas Analyzers
- Industrial Emissions Monitoring - Multi-Gas Monitoring Systems - CEMS
- Emissions Monitoring - Dilution Based Stationary Monitoring Systems
- Emissions Monitoring - Particulate Monitors
- Emissions Monitoring - Stack Flow Meter
- Engine Gas Monitoring - Turnkey Multi-Gas Cabinet
- Continuous Emissions Monitoring (CEM) of Hg in Stack Gas
- Multi-Chamber Filter Performance Monitors
- Powder Flow Monitors
- Filter Dust / Leak Monitors
- Rugged Sensor Options
- Process - Dust Measurement
- Process Optimization - Gas Monitors - Measured Parameter - HC/HCT
ENVEA products
Emissions - Engine Exhausts Monitoring
ENVEA - Model LGD 2M - Laser Gas Detection Module NH3 (TDLS)
Rack 3U monitor using the TDL extractive technology to measure online the NH3 pre and/or post catalyst: SCR (Selective Catalytic Reduction) or SNCR (Selective Non-Catalytic Reduction) ENVEA is offering Laser Gas Detection (LGD) modules with exceptional advantages and value for the customer. Tunable Diode Laser Spectrometry (TDLS), enhanced by proprietary technology, is used for the measurement of CO2, NH3, CH4, HCl, (H2O).
ENVEA - Model BERYL 92M FTUV - Ammonia (NH3) Analyzer (Fourier Transform technology)
Ultra-fast NH3 measurement (Ultra-fast response time : < 2 seconds). The use of the UV range for the measurement of NH3 has been specifically selected to avoid any interference with other major emission gases (CO, CO2, H2O etc..) that do not absorb in the UV.
ENVEA - Model EGAS 2M - Engine Exhaust Gas Analysis Systems (EGAS)
The only system allowing the measurement of 1 or 2 independent streams in a single analysis cabinet.
ENVEA - Model Mini DeNOx - Cabinet Heated Turnkey Gas Analysis System
Heated Turnkey Gas Analysis System ideally suited for fast, continuous and simultaneous measurements of NH3 and NOx in DeNOx applications (SCR and SNCR). In DeNOx systems using urea injection with ammonia (NH3) as a reducing agent, the flow rate and control of NH3 must be continuously adjusted and controlled to prevent excess NH3 emissions (slip), to reduce environmental impact and cost of reagents. To optimize this process, it is essential to use an emissions analysis system for simultaneous and continuous monitoring of NOx and NH3.
ENVEA - Model MIR 2M - CO, CO2 and O2 Multi-Gas Infra-Red Analyzer
Exists in single or dual stream version and “Ultra Low” version for low CO concentration measurements (0-10 to 0-50 ppm) Installed downstream a chiller, controlled at 4°C.